The TT AirShooter is the device to thread the tail at press section. It consists in a manual device with an air blow nozzle and a guide plate that can be directed against the roll from where the tail must be threaded. The device cuts the tail with the air and addresses it either to the next press or in a dryer.

The fully manually operation leads to a very flexible device, orientation, time to thread and flying angle is left to the operator choice, so that there is full control of any parameter.

Both the tail detaching, flying and landing of the tail are managed by air flows. Single point air flow regulators make the equipment easily tuned to any peculiar Customer’s condition.